To install the water line, follow these steps: Do not overtighten the compression nut.
- Thank you for your feedback!.
- How to Hook Up a Water Line to a Refrigerator | HowStuffWorks?
- How to Hook Up a Water Line to a Refrigerator | HowStuffWorks?
Tighten the compression nut onto the union. This will clean the water supply system and clear air from the lines. Related Questions How to change the light bulb in Samsung Refrigerator? How to adjust the level of Samsung Refrigerator? How often to change the water filter for Samsung Refrigerator? Thank you for your feedback! Please answer all questions.
Email We'll respond within 24 hours of your request. Drill holes in the base cabinet walls to route the water line from beneath the sink to the rear of the refrigerator. Drill as close to the back wall of the cabinet as possible, so you do not lose storage space inside the cabinet.
Help Library
Thread the water line, included in the ice maker installation kit, from the area behind the refrigerator to beneath the sink. Leave the excess water line behind the refrigerator. Turn on the cold water faucet to drain any water left in the supply line. Use pliers to untwist the faucet supply line from the cold water supply valve.
How to Hook Up a Water Line to a Refrigerator From the Sink | Home Guides | SF Gate
Wrap threads on the cold water valve with two or three wraps of thread-seal tape. Twist the male end of a quick-tee adapter onto the valve. Wrap the female thread on the opposite end of the adapter with thread-seal tape. Twist the faucet supply line onto the female end of the adapter.
- small willy dating?
- find someones dating profile free?
- dating singles personals?
- best free dating site ukraine?
- How to Connect a Refrigerator Water and Ice Dispenser | This Old House?
Slip the compression nut that came with the kit over the newly installed supply line. Make sure the threads are facing the end of the line. Thread the ferrule from the kit onto the new line. Wrap the remaining male threads on the quick-tee adapter with thread-seal tape. Insert the new water line into the opening on the tee. Slide the compression nut over the male threads and tighten it on the adapter.
How to Connect a Refrigerator Water and Ice Dispenser
Tighten all three nuts on the quick-tee adapter with pliers or an adjustable wrench. Do not twist the nuts too tight as this could damage the supply valve, the supply line and the adapter. Place the end of the water line you intend to connect to the refrigerator into a 5-gallon bucket. Turn the cold water supply valve on beneath the sink. Let 1 or 2 gallons of water run through the new line to remove the air.
- speed dating in mauritius?
- dating sites in manila?
- 17 year old dating 20 year old illegal?
- Warranty & Support.
- Related Questions.
Turn off the supply line. Slip the remaining compression nut and ferrule over the refrigerator end of the new water line.
Connect the line to the water line connector on the back of the refrigerator.